This rod end connects a threaded rod to a pivoting or articulating point through an internal, right-hand thread, transferring axial and radial loads through a spherical plain bearing arrangement. The outer ring is made of brass, with a PTFE film sliding layer providing a maintenance-free running surface, eliminating the need for relubrication. Construction follows DIN ISO 12240-4, dimension series K, type F, open design. Net mass is 0.19 kg, and the bearing is supplied without sealing. The maintenance-free PTFE sliding layer allows the bearing to run dry, without grease or oil replenishment over its service life, which simplifies installation where relubrication access is limited. Being of open design and supplied without sealing, the bearing relies on a clean operating environment, as no integrated protection against contamination is provided. The internal right-hand thread allows direct mounting onto a threaded rod end, with the spherical bearing geometry accommodating angular misalignment between the connected components.