This plain bearing accommodates radial loads while allowing angular misalignment between shaft and housing through its spherical sliding surface. The sliding layer is made using ELGOGLIDE material, which permits maintenance-free operation without relubrication. Design follows DIN ISO 12240-1 in dimension series E, though the outside diameter and bore tolerances deviate from this standard. Net mass is 0.136 kg, and the bearing is sealed on both sides (2RS), protecting the sliding surface from contamination and moisture ingress. The maintenance-free sliding layer eliminates the need for grease or oil lubrication over the service life of the bearing, simplifying installation in applications where relubrication access is limited. The 2RS sealing arrangement further supports operation in environments where dirt or moisture exposure could otherwise compromise the sliding surface. Since dimensional tolerances for the outside diameter and bore differ from the DIN ISO 12240-1 standard, fitting clearances should be checked against the specific mounting requirements before installation.