Carries combined axial, radial and tilting moment loads through a single row of balls arranged for four-point contact, allowing one raceway design to absorb forces acting in multiple directions at once. External gear teeth machined on the outer ring enable direct drive engagement without a separate gear component. Overall height is 56.0 mm and net mass is 91.1 kg, values that determine mounting space and handling requirements during installation. The four-point contact arrangement takes up axial and radial loads together with tilting moments in one compact ring, so the bearing suits applications where a rotating structure must be supported and driven from a single interface rather than through separate axial and radial bearings. The external gear teeth allow torque to be introduced directly at the outer diameter, which simplifies alignment between the drive pinion and the slewing ring. As no interchange references are available, mounting dimensions and bolt patterns should be confirmed against the VSA201094-N-VSP-ZT drawing before installation.