This is a split plummer block housing designed to carry two bearing positions on a single shaft, with the bore diameter d equal to 60 mm. The housing, cap, and grease-guiding disc are made of grey cast iron GG 20. Mounting dimensions can be read from the catalogue drawing: A = 512 mm, D = 150 mm, H = 95 mm, J = 230 mm, L = 290 mm, N = 19 mm, b = 70 mm, w = 76.0 mm, A1 = 420.5 mm, A2 = 365.0 mm, A3 = 532 mm, H1 = 190 mm, H2 = 25 mm, J1 = 380 mm, L1 = 812 mm, L2 = 490 mm, da = 70 mm. These values define the base plate layout, bolt spacing, and overall housing height for alignment during installation. Both bearing positions are fitted with grease nipples, allowing relubrication of each seat without dismantling the housing, and the unit is supplied complete with seals to keep contaminants away from the bearing seats. The two-seat design on a common shaft line suits assemblies where a single shaft carries bearings at both housing positions, with the grease-guiding disc directing lubricant flow within the housing during operation.